adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- Thermal shock cracking in friction surface, over heated and over burned microstructure in sub surface, adhesive element diffusion from surface to center occur due to friction heat. Layer delamination occurs also on the worn surface of the steel.
因摩擦热的影响，制动后钢的摩擦表面出现热震开裂，表层组织过热甚至过烧，表面的粘着物由表向里扩散； - The results showed that for the material without graphite, the main wear mechanism was adhesive, the friction coefficient(μ) and wear rate(△ W) were larger;
结果表明：不含石墨时，材料的摩擦系数和磨损率均较大，磨损主要为粘着磨损； - It provides theoretical foundation for determining the size of pressing load. Finally, a fractal model of adhesive friction coefficient is proposed by comparing the normal elastic load with the normal plastic load acting on particle contact points.
最后，通过比较作用于颗粒接触点的法向弹塑性载荷，提出了粘着摩擦系数的分形模型。 - The adhesive forces and friction forces between antigen and antibody were investigated.
对抗原和抗体分子间相互作用的粘附力和摩擦力进行研究。 - Results show that for certain fractal dimension, the total adhesive friction coefficient reduces sharply as the normalized contact area increases.
结果表明，对于一定的分形维数，总的粘着摩擦系数随归一接触面积的增大而急剧减小。 - In the process of emergent brake, relations among brake press, parameters of the entire vehicle and adhesive coefficient between tire and road surface influence the distribution of brake disc friction temperature field greatly.
在紧急制动过程中，制动压力、整车参数以及轮胎与路面间附着系数之间的关系对制动器摩擦温度场分布有重要的影响。 - The cause of adhesive wear of plunger-cylinder wall friction pair in axial plunger pump and its solution
轴向柱塞泵柱塞&缸孔摩擦副粘着磨损原因及解决办法 - We also find that, due to the water vapor condensation, the adhesive force and friction coefficient on sample surfaces increase first, then decrease with the relative humidity increase.
由于强的亲水性，样品表面的摩擦系数和黏附力随着湿度的增大先逐渐增大，然后急剧减小。 - The main wear mechanisms of nylon 1010 composites are fatigue fracture and adhesive wear and it can be observed that the GF is rubbed, fractured and peeled off under dry friction condition.
干摩擦下的复合材料磨损以疲劳断裂和粘着为主，且纤维出现磨损、断裂及从基体中剥落的现象。 - Assuming that the yield pressure and the local adhesive friction coefficient are independent on the contact spot and equal to the average values in the plastic contact regimes, the total adhesive friction coefficient is given by simple formulae.
假设屈服压力及局部粘着摩擦系数不依赖于接触斑点且等于塑性接触区中的平均值，则总的粘着摩擦系数可用简单的表达式描述。